Selecting The Speaker Mode; Speaker Menu; Selecting The Downmix Mode - Downmix; Selecting The Digital Audio Output Mode - Sony MV-65ST Mode D'emploi

Selecting the speaker
mode

— SPEAKER menu

Selecting the downmix mode
— DOWNMIX
You can select the downmix mode from
"STEREO" or "LT/RT." The downmix
function is used to create stereo (2-channel)
signals from more than 5 separated digital
signals of a source.
STEREO: Select this when the connected audio
equipment does not support Dolby
Surround (Pro Logic).
LT/RT: Select this when the connected audio
equipment supports Dolby Surround
(Pro Logic).
1
Press (SETUP), then press < or ,
button repeatedly until "SPEAKER" menu
appears on the screen.
2
Press M or m button repeatedly to select
"DOWNMIX."
3
Press < or , button repeatedly to
select "STEREO" or "LT/RT," then press
(ENTER).
4
Press (SETUP) to exit the SPEAKER
menu.
Selecting the digital audio
output mode
You can set the mode of the audio signals
output from the OPTICAL OUTPUT
connector. "BITSTREAM" or "LPCM 48K" can
be selected.
1
Press (SETUP), then press < or ,
button repeatedly until "AUDIO" menu
appears on the screen.
2
Press M or m button repeatedly to select
"DIGITAL OUTPUT."
3
Press < or , button repeatedly to
select "BITSTREAM," "LPCM 48K," or
"OFF," then press (ENTER).
4
Press (SETUP) to exit the AUDIO menu.
Notes
• When "OFF" is selected, no signal is output from
the OPTICAL OUTPUT connector.
• When you connect the player and a digital
recording device such as an MD player through
an optical cable to record the CD contents with
that device, the contents will be recorded as one
continuous track.

— AUDIO menu

25