Mounting And Operation - HIKOKI C 18DBAL Mode D'emploi

page de 229

/ 229
Matières
Table des Matières
Signets

Table des Matières

Les langues disponibles

English

Before

charging

While charging

Charging

complete

Pilot lamp

(red)

Overheat

standby

Charging

impossible

● Regarding the temperatures and charging time of the

battery.

The temperatures and charging time will become as

shown in Table 2.

Battery

Charging voltage

Weight

Temperatures at which the battery

can be recharged

Charging time for battery capacity,

approx. (At 20°C)

BSL14xx series, BSL18xx series

1.5 Ah

2.0 Ah

2.5 Ah

3.0 Ah

4.0 Ah

5.0 Ah

6.0 Ah

Multi volt series

BSL36A18

BSL36B18

Number of battery cells

NOTE

The recharging time may vary according to temperature

and power source voltage.

CAUTION

When the battery charger has been continuously used,

the battery charger will be heated, thus constituting

the cause of the failures. Once the charging has been

completed, give 15 minutes rest until the next charging.

4. Disconnect the charger's power cord from the

receptacle.

5. Hold the charger ﬁ rmly and pull out the battery.

NOTE

Be sure to pull out the battery from the charger after use,

and then keep it.

Indications of the pilot lamp

Lights for 0.5 seconds. Does not light for 0.5

Blinks

seconds. (oﬀ for 0.5 seconds)

Lights continuously

Lights

Lights for 0.5 seconds. Does not light for 0.5

Blinks

seconds. (oﬀ for 0.5 seconds)

Lights for 1 second. Does not light for 0.5

Blinks

seconds. (oﬀ for 0.5 seconds)

Lights for 0.1 seconds. Does not light for 0.1

seconds. (oﬀ for 0.1 seconds)

Flickers

Table 2

Charger

UC18YFSL

14.4 – 18

0.5

0°C – 50°C

min.

120

4 – 10

Table 1

CAUTION

○ If the battery is charged while it is heated because it has

been left for a long time in a location subject to direct

sunlight or because the battery has just been used, the

pilot lamp of the charger lights for 1 second, does not

light for 0.5 seconds (oﬀ for 0.5 seconds). In such a case,

ﬁ rst let the battery cool, then start charging.

○ When the pilot lamp ﬂ ickers (at 0.2-second intervals),

check for and take out any foreign objects in the charger's

battery connector. If there are no foreign objects, it is

probable that the battery or charger is malfunctioning.

Take it to your authorized Service Center.

○ Since the built-in micro computer takes about 3

seconds to conﬁ rm that the battery being charged with

charger is taken out, wait for a minimum of 3 seconds

before reinserting it to continue charging. If the battery

is reinserted within 3 seconds, the battery may not be

properly charged.

○ If the pilot lamp does not blink in red (every second)

even though the charger cord is connected to the power,

it indicates that the protection circuit of the charger may

be activated.

Remove the cord or plug from the power and then

connect it again after 30 seconds or so. If this does

not cause the pilot lamp to blink in red (every second),

please take the charger to the HiKOKI Authorized

Service Center.