Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To reduce the risk of injury, wear a dust mask and safety
glasses with side shields. Unplug the tool before changing
accessories or making adjustments.
Selecting Sandpaper and Grits
Aluminum oxide, silicon carbide or other synthetic abrasives are recom-
mended for power sanding. A garnet sandpaper is acceptable, but has a
short life.
Start your work with an abrasive grit just coarse enough to remove high
spots and excessive roughness. Follow with a second sanding using a
grit one or two grades finer. Continue with successively finer grits until
you obtain the desired finish.
Do not switch from a coarse grit to a very fine grit in one step because
it may be impossible to remove the swirl marks made by the coarse grit
abrasive. Use the finest grits practical for the roughing operation, and
finish by using successively finer grits.
General Sanding
1.
To prevent rough action due to starting under load, turn ON/OFF
Switch ON before applying sander to workpiece.
2.
Work in slow, overlapping strokes parallel to grain. Your Finishing
Sander is designed for even weight distribution. Excessive pres-
sure may damage workpiece and motor as well as cause premature
sandpaper wear.
3.
Repeat operation using successively finer grits of sandpaper until
desired finish is obtained. Example: 60 Coarse, 100 Medium, 150
Fine.
page 6
WARNING!
OPERATION
Removing Paint and Varnish
1.
If you use liquid removers or heaters to speed your work, be sure
surface is cool and dry. Before applying sander, remove excess
material with putty knife or other suitable scraping tool.
2.
Use coarse, open coat abrasive to avoid usual clogging of abrasive
surface.
3.
To avoid heating and softening of material being removed, keep
Finishing Sander moving over new areas.
4.
Work in wide, overlapping arcs for uniform finish. Do not concen-
trate on small areas
Cabinets and Doors
Because your Finishing Sander works with circular movements, you
may sand joining pieces in any direction regardless of grain. Properly
changing from coarse to fine grit abrasives, will result in an excellent
finish.
Publicité
Table des Matières
