Instruction For Use - Bartscher WE-11 Notice D'installation Et Mode D'emploi

• safety fuse of the feeder and inner mains can stand the loading of the device (see label of the matrix)
• mains are equipped with effective grounding according to standards (ČSN) and conditions given by law
• socket or switch of the feed is well accessible from device
We refuse any responsibility in case of not respecting above mentioned rules. Before the first use it is necessary
to remove all the protection foil and to clean the device - see chapter „cleaning and maintenance".
Before the first use it is necessary to remove all the protection foil and to clean the device - see chapter „cleaning
and maintenance".
Maintenance
We recommend to have the device checked once a year by the proffesional service. Only qualified or competent
persons can do interventions in the product.

INSTRUCTION FOR USE

Attention! Before the first use of the device you must remove protection foil and wash the device with water
containing detergent and than dry with the cleaning cloth.
Fill the device with water 1 cm high and put the false bottom. Switch on with main switch (B) turn the knob (E)
from the position „0" to required position between 30°C - 90°C. Pilot lamps (C) and (D) will light. Pilot lamp (C)
lights when the device is in electricity. Pilot lamp (D) lights when the thermo spirals are on. Pilot lamp (D) goes
out when the device reaches required temperature. Switch the device off by turning the knob (E) into position „0"
and switch over the switch (B). Control the level of the water, never use the device without water. Use the device
under supervision.
Discharging of the bath
Discharge the bath when the water is cold and the device is disconnected from the electricity. By the models
with outlet just lift the safety catch of the outlet cock and turn to the right. Than give the device to the previous
position and save the cock by safety catch again.
B
C
D
E
5