Troubleshooting - Bosch VitaExtract MESM7 Série Mode D'emploi

en

Troubleshooting

Troubleshooting
Problem
The appliance
does not start when
switched on.
The appliance stops
during use.
The juice drum
cannot be positioned
on the base unit
correctly.
The juice is too
runny or too viscous.
The appliance motor
is running loudly.
If you are unable to solve the problem, always call the hotline!
You will find the telephone numbers at the back of these instructions.
18
Reason
Appliance has no power supply.
The lid is not sitting correctly on
the juice drum.
The appliance stopped during
use.
Too much food to be squeezed
or hard seeds/stalks in the
appliance.
The lid is not sitting correctly on
the juice drum.
The adjusting lever for fruit
pulp is incorrectly adjusted or
the seal is not in the correct
position.
The adjusting lever for fruit
pulp is incorrectly adjusted or
the seal is not in the correct
position.
Quantity in the appliance is too
large.
The appliance is incorrectly
assembled.
Remedy
Insert the mains plug into the
socket.
Place the lid onto the juice drum
correctly. Observe the markings.
If the lid cannot be closed,
disassemble and reassemble
the parts again. Ensure that all
individual parts sit correctly.
The reversing function must
be used for several seconds or
it will no longer be possible to
switch on the appliance.
The reversing function must
be used for several seconds
or it will no longer be possible
to switch on the appliance.
X "Reversing function" see
page 16
Place the lid onto the juice drum
correctly.
Check the setting/seal.
X "Adjusting lever / seal for fruit
pulp" see page 14
Check the setting/seal.
X "Adjusting lever / seal for fruit
pulp" see page 14
Do not process excessive
quantities simultaneously.
Disassemble and reassemble
the appliance as described.
X "Preparation" see page 14