To Stop The Product - Husqvarna 120i Manuel D'utilisation

Note: The SavE function does not decrease the cutting
power of the product.
1. Press the SavE button on the keypad.
2. Make sure that the green LED comes on.
3. Press the SavE button again to disconnect the
function. The green LED goes out.

To stop the product

1. Press and hold the start/stop button on the keypad
until the green LED light comes off.
2. Pull out the battery and press the battery release
buttons to remove the battery from the battery
holder.
WARNING: Remove the battery when you
do not use or when you do not have full
vision of the product. This is to prevent
accidental start.
What is kickback?
WARNING: If a kickback occurs when the
saw chain rotates, it can cause serious
injuries or death to the operator. It is vital
that you understand the causes of kickback
and that you can prevent them with correct
working technique. If you are prepared you
decrease the risk.
A kickback occur when the kickback zone touches an
object with a rotating saw chain. A kickback can occur
805 - 002 -
suddenly and with large force, which throws the product,
guide bar and saw chain against the operator.
Kickback always occurs in the cutting plane of the guide
bar. Usually, the product, guide bar and saw chain are
thrown against the operator but can also move in a
different direction. It is how you use the product when
the kickback occurs that causes the direction of
movement.
Kickback only occurs if the kickback zone of the guide
bar touches an object. Do not let the kickback zone
touch an object.
The smaller the bar tip radius the lower the risk of
kickback.
A saw chain is made up of a number of links, which are
available as standard and low kickback. You can
decrease the effects of kickback by using the correct
cutting equipment with kickback reduction.
WARNING: No saw chain fully prevents the
dangerous situations that can occur during a
kickback.
15