Blade Assembly - Dremel 670 Mode D'emploi Et Consignes De Sécurité

Note: If the collet nut and collet are not
removed from the motor shaft, the tool will not
function properly.
Step 4. Install the drive adapter on the motor
shaft and tighten.
To prevent damage to tool,
CAUTION
!
do not over tighten drive
adapter. Tighten the drive adapter finger tight
and then tighten an additional 1/3 turn with the
wrench. (Wrench is included with your rotary
tool kit.)
12
DV-2610917718, Page: MUL (VAA), downloaded at: 2016.01.05_00:20:05, by PT-RT/MKP1_Fulvio.Camarotto
Step 5. Screw the attachment onto your rotary
tool until the coupling is tight against the hous-
ing. Hand tighten only. The attachment should
be oriented on your rotary tool so that the speed
control switch on the tool is easily accessible.

BLADE ASSEMBLY

Disconnect the plug of your
! WARNING
rotary tool from the power
source before making any assembly,
adjustments or changing accessories. Such
preventive safety measures reduce the risk of
starting the tool accidentally.
Always use Dremel Saw
! WARNING
Blades. Blades that do
not match mounting hardware will run
eccentrically, causing loss of control.
13