Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CUTTING LARGE SHEETS
Large sheets and long boards sag or bend,
depending on support. If you attempt to cut
without leveling and properly supporting the
piece, the blade will tend to bind, causing
KICKBACK and extra load on the rotary tool. (Fig. 1)
Figure1
Kickback
Support the panel or board close to the cut, as
shown in (Fig. 2). Be sure that you cut through
the sheet or board only and not the table or
work bench. The two-by-fours used to raise
and support the work should be positioned so
that the broadest sides support the work and
rest on the table or bench. Do not support the
work with the narrow sides as this is an
unsteady arrangement. If the sheet or board to
be cut is too large for a table or work bench,
use the supporting two-by-fours on the floor
and secure.
18
DV-2610917718, Page: MUL (VAA), downloaded at: 2016.01.05_00:20:06, by PT-RT/MKP1_Fulvio.Camarotto
Figure 2
Feed Direction
Maintenance
SERVICE
Preventive maintenance
WARNING
!
performed by unauthorized
personnel may result in misplacing of internal
components which could cause serious
hazard. We recommend that all tool service be
performed by a Dremel Service Facility.
TOOL LUBRICATION
Your saw attachment has been properly lubricated
and is ready to use.
19
Publicité
Table des Matières
