Warranty & Service - SEVERIN KS 9770 Notice D'utilisation

Masquer les pouces Voir aussi pour KS 9770:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 21
Remarks on the appliance operating noise. As the appliance operates and goes through the freezing cycle,
various noises will be emitted. This is normal and is not a sign of any malfunction.
 As the refrigerant circulates around the refrigeration system, it causes sounds like murmuring, bubbling, or
rustling.
 Louder sounds like popping or clicking may be heard for a short time as the refrigerator's compressor switches
on.
Operation problems and their solutions (troubleshooting)
What if ...
 The appliance is plugged in to the mains but it does not work and the electricity supply voltage indicator
is not illuminated. Check that your house electricity supply installations are in order. Check that the plug is
correctly inserted into the electricity supply socket.
 The noise has become louder. Check that the appliance is standing stable, on a level place. To make it level,
regulate the front feet. Check if the appliance is not touching any furniture, and that no part of the refrigeration
system at the back part of the appliance body is touching the wall. Pull the appliance away from any furniture
or walls. Check that the cause of increased noise isn't due to bottles, cans or dishes in the appliance that might
be touching each other.
 Water has appeared at the bottom of the refrigerator compartment. Check whether a thaw water channel
space isn't blocked. Clean the thaw water channel space with a cleaner intended for that purpose.
 Water has appeared on the tempered glass shelves. Food items or dishes in the refrigeration compartment
are touching the back wall of the compartment. Do not let food items or dishes touch the back wall.
 Water has appeared under the appliance. The thaw water collection tray has slipped off the compressor.
Place the tray on top of the compressor.
 When the appliance door is opened, the rubber sealing gasket pulls out. The gasket is smeared with sticky
foodstuffs (fat, syrup). Clean the sealing gasket and the groove for it with warm water containing soap or
dishwashing detergent and wipe dry. Put the rubber sealing gasket back into the place.
 High temperature in appliance, the compressor operation pauses are short. Ascertain whether the
appliance door is shutting tightly, whether the door wasn't kept open longer than necessary when taking out or
putting in foodstuffs, or whether a large amount of warm food was placed in the appliance.
 The top of the appliance has condensation on it. The ambient relative air humidity is above
Ventilate the room where the appliance stands, and if possible remove the cause of the humidity.
Warranty service
! IF YOUR APPLIANCE IS NOT WORKING PROPERLY,
ASCERTAIN WHETHER YOU CAN REMEDY THE
CAUSE OF THE FAULTY FUNCTIONING OF THE
APPLIANCE YOURSELF. If you cannot solve the problem
yourself, contact the nearest refrigerator service representative
by telephone or in writing. When making contact, necessarily
indicate the refrigerator model (article). You will find this data
on the product label, which is glued to the wall of the
refrigerator compartment, near the fruit and vegetable trays.
Tra n spo rt
! THE MANUFACTURER WILL NOT BE RESPONSIBLE FOR ANY DAMAGE TO THE APPLIANCE
THAT RESULTS FROM NON-COMPLIANCE WITH THE INSTRUCTIONS FOR TRANSPORTATION.
 The appliance should be transported only in the vertical position.
 When being transported, the appliance should be protected from atmospheric conditions (rain, snow,
dampness).
 The appliance should be firmly secured in place while being transported, to avoid slippage or any shocks in the
transport vehicle.
 If the appliance was transported not vertically, it may be connected to the mains after 4 hours at least. If this is
not done, the appliance compressor may fail.
36
GB
70 %.

Publicité

Table des Matières
loading

Table des Matières