Abus IPCS10020 Manuel Utilisateur page 111

Drag the mouse pointer over the desired area. Set the sensitivity using the regulation control bar. To apply the
setting for the area, click on "Stop Drawing".
Right: low sensitivity level.
Left: high sensitivity level.
Arming Schedule
To save a schedule for the video tampering, click on 'Edit'.
A new window appears. Specify here on which days of the week and at which times the video tampering
alarm should be enabled.
Now select a day of the week for the video tampering. To store particular time periods, enter a start and end
time. To set up all-day video tampering, select 00:00 as the start time and 24:00 as the end time.
To activate video tampering for all days of the week, click the 'Select All' checkbox. To copy the video
tampering to other days of the week, select the day of the week and click 'Copy'.
To apply the changes, click "OK" and to discard them click "Cancel".
Linkage Method
Here you can set the action to be performed in case of video tampering.
Normal Linkage
Send email: You receive an email as notification; check the checkbox to activate this.
Other Linkage
You can switch on the alarm output when tampering is detected.
To switch on alarm output 1, select 'A->1'.
Apply the settings by clicking "Save".
112