Agri-Fab 45-02114 Notice D'utilisation page 6

11. Turn the spreader upright on its wheels.
12. Assemble the hitch bracket to the top of the hitch tube
using two 1/4" x 1" hex bolts (B) and 1/4" nylock nuts
(D). See figure 5.
13. Assemble the hitch pin (K) through the hitch bracket
and the hitch tube and secure with the hair cotter pin
(J). See figure 5.
(K) HITCH PIN
FIGURE 5
14. Assemble the flow control link (O) (end with small hole)
to the flow control arm using a 1/4" x 1" hex bolt (B),
a nylon washer (E) and a 1/4" nylock nut (D). Tighten
carefully. The flow control link should not be loose but
should pivot with no more than slight resistance. See
figure 6.
(O) FLOW CONTROL
LINK
(B) 1/4" x 1"
HEX BOLT
SMALLEST
HOLE
(E) NYLON
WASHER
FIGURE 6
(B) 1/4" x 1"
HEX BOLT
(D) 1/4" NYLOCK
NUT
(J) HAIR COTTER PIN
FLOW
CONTROL
ARM
(D) 1/4"
NYLOCK NUT
ENGLISH
15. Assemble the flow control arm to the flow control
mounting bracket using a 1/4" x 1" hex bolt (B), two
nylon washers (E) and a 1/4" nylock nut (D) as shown in
figure 7. Tighten carefully. The flow control arm should
pivot with a slight resistance.
16. Assemble the vinyl grip (P). See figure 7.
(P) VINYL GRIP
FLOW
CONTROL
ARM
(B) 1/4" x 1"
HEX BOLT
FIGURE 7
17. Place a 5/16" flat washer (F) onto the end of the flow
control rod. Insert the end of the rod through the slot in
the flow control mounting bracket and through the hole
in the flow control link (O). Secure with a 3/32" x 3/4"
cotter pin (H). See figure 8.
(F) 5/16" FLAT
WASHER
FLOW
CONTROL
ROD
FIGURE 8
6
FLOW CONTROL
MOUNTING
BRACKET
(D) 1/4"
NYLOCK NUT
(E) 2 NYLON
WASHERS
(H) 3/32"
COTTER
PIN
SLOT
(O) FLOW
CONTROL
LINK