Sub-Zero ICB424G Guide D'utilisation Et D'entretien page 10

Wine Storage Use & Care
Door Operation
DOOR CLOSING
The door of your wine storage unit has a spring-loaded
closure mechanism. s the door is closed, the door closer
engages to help close and seal the door.
90° DOOR STOP
If your wine storage unit is positioned in a corner, you may
want to limit the door opening to 90°.
IMPORT NT NOTE: 90° door stop is not available for
models ICB424 and ICB424FS.
For models ICB427 and ICB427R, a 90° door stop built
into the hinge system. You can easily actuate the stop by
using a blade-type screwdriver and rotating the brass cam
in both the top and bottom hinges. You must position both
stops at 90° if you want to safely use the door. You can go
to the maximum of a 105° door opening by using the
screwdriver and rotating the brass cam to the next stop.
Refer to the illustration below.
For model ICBWS-30, a 90° door stop ships with the unit
and is located behind the flip-up grille. Refer to the illus-
tration below.
90° door stop
(model ICBWS-30).
90° door stop
(models ICB427 and
ICB427R).
The door swing on models ICB427 and ICB427R may
cause severe finger pinching. Watch that fingers are
not placed in the door opening on the hinge side
when the door is open.
Lighting Information
C BINET LIGHTING
For models ICB424 and ICB424FS, rope-style lighting is
mounted to the top of the cabinet and cascades down the
entire front of the unit.
Models ICB427, ICB427R and ICBWS-30 have discreet
lighting provided in two places. Rope-style lighting is
mounted to the top of the cabinet and additional lighting is
mounted in the control panel to illuminate the display
shelf. Refer to the illustration.
These lights have an extended life and it should be some
time before they need to be replaced. If you have
problems with the cabinet lighting or need replacements,
contact your Sub-Zero dealer.
Shut off power to the unit before replacing light bulbs.
Wear protective gloves when handling bulbs.
CABINET
LIGHTING
DRAWER
LIGHTING
Cabinet lighting (models Drawer compartment
ICB427, ICB427R and lighting (model ICB427R).
ICBWS-30).
DR WER LIGHTING—MODEL ICB427R
Lighting is recessed into the top area of each refrigerator
drawer compartment of model ICB427R. Refer to the illus-
tration above.
To replace a light bulb in the drawer compartment, you
must pull the drawer out to its maximum extension. It is
recommended that you remove the drawer. Refer to page
9 for the drawer removal procedure.
Remove the 15-watt bulb by unscrewing it from its socket
and complete the reinstallation by following the reverse
steps.
10