Status Led; Operation; Reset Button; Microsd Card - Kemper 611 00 Manuel D'utilisation

EN
4.3
The 2-colour LED displays the operation and
status of the data logger.
LED
LED lamp lights up green
LED lamp lights up red
LED lamp flashes red
LED lamp rapidly flashes green
LED lamp slowly flashes green
5
5.1
Restarting the data logger:
Press and hold reset button for 5 seconds..
5.2
After the microSD card is inserted for the
first time, the data from the controller's flash
memory (8MB) are automatically copied to the
microSD card when the controller is switched
on.
Thereafter, all data are stored on the microSD
card.
20/ 64 – K410061100000-00 – 07.2020 – © www.kemper-olpe.de

Status LED

Everything OK (default state, if no data are transmitted) – microSD card
OK and CAN bus available
MicroSD card not OK or none inserted
CAN bus not OK – CAN not connected
Data are being copied to the SD card (every minute or the first time it is
connected, when the memory contents are transferred from the control-
ler)
At start – CAN is being initialised

Operation

Reset button

MicroSD card

Status
If necessary, a firmware update can also be
imported from the microSD card (see 5.4.
Firmware update).
Only remove the SD card when the
device is switched off.