Safety Instructions - Kemper 611 00 Manuel D'utilisation

Safety instructions to be observed during assembly
and electrical installation

Safety instructions

Be sure to read and follow the safety instruc-
tions in the manual. Failure to follow the safety
instructions can result in injury or even death
and in damage to property.
Labelling of important warning information:
Danger! Electricity!
Indicates hazards that may result in
severe or fatal injury.
Note!
Indicates hazards that may result in
system damage or malfunctions.
Info
Indicates additional information and
tips.
Danger!
Have work carried out
only by plumbingspecialists who
have received training in electrical
installation work.
Warning!
Priority must be given to the natio-
nal standards and provisions governing accident
prevention.
Note!
Use the data logger and gateway
- only in perfect condition
- as intended.
© www.kemper-olpe.de – 07.2020 – K410061100000-00 – 15/64
Danger! Electricity!
Danger of fatal electric shock!
• Disconnect the system from the
power supply before carrying
out work.
Note!
Warranty is voided if the data
logger and gateway are connected
to an unsuitable power supply or
the housing is opened. There are
no operating elements inside the
housing.
Note!
Only install the data logger in dry
areas and under ambient condi-
tions as described under section 1,
Technical Data.
Note!
Only remove the SD card when the
device is switched off. Removing the
SD card during a read or write ope-
ration can cause irreparable damage
to the SD card.