Service And Repair; Storage; Troubleshooting - FUXTEC FX-KM196 Mode D'emploi

Original-Bedienungsanleitung Benzin-Kehrmaschine FX-KM196_de_en_fr_ita_rev07
Height adjustment of Caster Wheels & Brushes
Once the brushes get worn, it is necessary to adjust the height of the
brushes, i.e. how close they are to the surface to sweep. This adjustment
takes place by moving the plastic rings of the brush caster wheels. See as
follows:
1. Loosen the side knob (fig. 10.A);
2. Rotate the upper knob (fig. 10.B) in clockwise /
anticlockwise to lift / lower the small wheels;
3. Fix the side knob (fig. 10.A);
9. Service a Repair
• Repair or adjust the sweeper in a safe area, away from traffic and other
hazards.
• Before adjusting or servicing remove spark plug wire from the spark
plug.

10. Storage

NOTICE:
• Do not store the sweeper with weight on the brush. Weight will deform
the bristles, destroying the sweeping effectiveness.
• Do not store polypropylene brushes in direct sunlight. The material can
deteriorate and crumble before the bristles are worn out.
• Keep polypropylene brush material away from intense heat or flame.

11. Troubleshooting

The engine does not start
The engine runs irregularly
Ensure that the spark plug is not defective
Ensure that the spark plug cap is fitted
correctly
Ensure that the choke is deactivated
Ensure that there are no impurities in the fuel
38