Engine Operations - FUXTEC FX-KM196 Mode D'emploi

Original-Bedienungsanleitung Benzin-Kehrmaschine FX-KM196_de_en_fr_ita_rev07
b) Insert the screws in the
holes and secure in place
with the nuts.
2. Installation
control
a. Remove the
assembled articulated joint
(fig. 5.A) on the washer
gear control (fig. 5.B) and
nut (fig. 5.C).
b. Insert the articulated joint
(fig. 5.A)
control in the hole on the
lever (fig. 5.D) to connect
it to the transmission.
c. Secure the washer (fig. 5.B) and nut (fig. 5.C).
3. Brush directional
assembly
d. Remove the
assembled articulated joint
(fig. 6.A) on the brush
directional control nut (fig.
6.B).
e. Insert the articulated joint
(fig. 6.A) on the directional
brush control in the lever
hole (fig. 6.C) to connect it
to the drive.
f. Secure the nut (fig. 6.B).

6. Engine Operations

NOTICE: THE ENGINE IS DELIVERED WITHOUT OIL AND GASOLINE.
Oil Filling:
Place the engine in a horizontal position. Remove the plug and fill with oil
right to the edge. (Figure 7)
of the gear
previously
of the gear
control
previously
32