Assembly - FUXTEC FX-KM196 Mode D'emploi

Original-Bedienungsanleitung Benzin-Kehrmaschine FX-KM196_de_en_fr_ita_rev07
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Dispose of the box and packaging in compliance with local regulations.

5. Assembly

Please note that during assembly, maybe you'll need a helper!
Forward and brush control cable assembly
Couple the cable eyelet to the specific opening (fig. 3).
NOTE: The cables are already pre-assembled on the dashboard.
1. Handle assembly
The handle is delivered with
the dashboard already
assembled. The device handle
assembly screws, gear control
fastening screws and nuts and
bolts to secure the directional
brush control are provided in a
separate package found in the
machine packaging. Install as
follows:
a) Bring the two tubes at the
ends of the handle (fig. 4.A)
up to the support (fig. 4.B).
31