Milwaukee 9070-20 Manuel De L'utilisateur page 6

To reduce the risk of injury, wear safety goggles or
glasses with side shields. Unplug the tool before
changing accessories or making adjustments.
Using the Forward/Reverse Switch (Fig. 6)
Cat. No. 9072-20, 9092-20, and 9096-20
This impact wrench is equipped with a forward/reverse switch that may
be set to forward or reverse rotation.
Fig. 6
Reverse
1. For forward (clockwise) rotation, push the forward/reverse switch in
the direction shown. Check the direction of rotation before use.
2. For reverse (counterclockwise) rotation, push the forward/reverse
switch in the direction shown. Check the direction of rotation before
use.
To reduce the risk of injury, keep hands and cord
away from the bit and all moving parts.
To reduce the risk of explosion, electric shock and
property damage, always check the work area for
hidden pipes and wires before drilling.
To reduce the risk of injury, only grasp tool by
handle and red insulated surfaces (Fig. 7). Do not
hold gray gear case when impacting or drilling.
Fig. 7
page 6
WARNING!
Forward
Forward/ Reverse
Switch
WARNING!
WARNING!
WARNING!
OPERATION
Starting, Stopping and Controlling Speed (Fig. 8)
Cat. No. 9072-20, 9092-20, and 9096-20
Fig. 8
Speed dial
This impact wrench may be operated at any speed from 0 to full speed.
The speed will remain variable up to the chosen speed dial setting by use
of the trigger. The speed dial turns clockwise to increase the speed or
counterclockwise to decrease the speed (Fig. 8).
1. Select a speed on the speed dial.
2. To start the tool, pull the trigger.
3. To vary the driving speed, increase or decrease pressure on the trig-
ger. The further the trigger is pulled, the greater the speed.
4. To stop the tool, release the trigger.
Starting and Stopping the Tool (Fig. 9)
Cat No. 9070-20, 9071-20, 9075-20
Fig. 9
Rocker
switch
These impact wrenches are equipped with a rocker switch that offers
both forward and reverse rotation.
1. For forward (clockwise) rotation, pull the lower portion of the switch.
2. For reverse (counterclockwise) rotation, pull the upper portion of the
switch.
NOTE: To prevent damage to the motor and internal mechanism, allow
the motor to stop completely before switching from forward to reverse or
from reverse to forward.
Impacting Techniques
The longer a bolt, screw, or nut is impacted, the tighter it will become. To
help prevent damaging the fasteners or workpieces, avoid excessive im-
pacting. Be particularly careful when impacting smaller fasteners because
they require less impacting to reach optimum torque.
Practice with various fasteners, noting the length of time required to reach
the desired torque. Check the tightness with a hand-torque wrench. If the
fasteners are too tight, reduce the impacting time. If they are not tight
enough, increase the impacting time.
Impacting for two seconds is generally sufficient for a 3/8" bolt and one
second for a 5/16" bolt. However, oil, dirt, rust or other matter on the
threads or under the head of the fastener affects the degree of tightness.
The torque required to loosen a fastener averages 75% to 80% of the
tightening torque, depending on the condition of the contacting surfaces.
However, if rust or corrosion causes seizing, more torque may be required.
On light gasket jobs, run each fastener down to a relatively light torque
and use a hand torque wrench for final tightening.
Trigger
To increase
the speed