Pioneer ELITE BDP-62FD Mode D'emploi page 52

08
Problem
Noise can be heard when
outputting DTS Digital Audio
signals from the DIGITAL
OUT terminal.
192 kHz or 96 kHz digital
audio signals cannot be
output from the DIGITAL
OUT terminal.
Secondary audio or
interactive audio is not
output.
Sound is fast or slow.
After a disc is inserted,
Loading stays displayed and
playback does not start.
 is displayed in file names,
etc.
A message indicating low
memory appears while
playing a BD-ROM disc.
52
En
Check
Is the connected AV receiver
or amplifier compatible with
DTS Digital Surround?
Is HDMI Audio Out properly
set?
Are Digital Output properly
set?
When an HDMI cable is
connected, are audio signals
being output from devices
connected with cables other
than HDMI cables?
Are there too many files
recorded on the disc?
Remedy
If an AV receiver or amplifier that is not compatible with DTS Digital
Surround is connected to the DIGITAL OUT terminal, set Digital
Output to PCM (page 39).
• Copyright-protected audio is converted to 48 kHz or less before
output.
• Set Downsampling to 96KHz or 192KHz (page 39).
When listening to the sound from an HDMI OUT terminal, set HDMI
Audio Out to PCM (page 40).
When listening to the sound from an DIGITAL OUT terminal, set
Digital Output to Re-encode or PCM (page 39).
When a Pioneer AV receiver or amplifier compatible with the PQLS
function is connected directly to the player's HDMI OUT terminal using
an HDMI cable, the PQLS function is activated when playing an audio
CD (CD-DA). Because of this, the sound output from components other
than the ones connected by an HDMI cable may be fast or slow. If this
happens, set Control to Off (page 40).
When a disc on which files are recorded is inserted, depending on the
number of files recorded on the disc, loading may take several dozen
minutes.
The characters that cannot be displayed on this player are displayed in
.
• Connect a USB device (page 20).
• Erase the data stored on the connected USB device from BUDA
Setup (page 43).