Inserting The Bobbin - Janome HF8077 Manuel D'instructions

z z z z z
q
x x x x x
c c c c c
t
v v v v v
t
b b b b b
w
e
r
y
22

Inserting the bobbin

1 Place the bobbin in the bobbin holder with the
thread running off counterclockwise.
q Thread
w Bobbin holder
2 Guide the thread into the notch on the front of the
bobbin holder.
e Notch on the front
3 Draw the thread to the left, sliding it between
the tension spring blades.
r Spring blades
4 Continue to draw the thread lightly until the thread
slips into the notch on the side.
t Notch on the side
5 Pull out about 10 cm (4") of thread to the rear.
Reattach the hook cover plate.
NOTE:
A threading chart is shown on the hook cover plate
for your reference.
y Threading chart