Mode Key - Janome HF8077 Manuel D'instructions

r
(1)
(2)
(3)
r

Mode key

Each time you press this key the mode will change in
the following order:
(1) Pattern selection mode
The green light on the top will be on.
To select the pattern, press the
pattern number of the desired stitch is indicated (see
the stitch chart below).
(2) Stitch width adjusting mode
The green light in the middle will light up.
The stitch width of the selected pattern will be
indicated.
To alter the stitch width, press the
(3) Stitch length adjusting mode
The green light on the bottom will light up.
The stitch length of the selected pattern will be
indicated.
To alter the stitch length, press the
12
key until the
key.
key.