Horizon Hobby Dynamite FUZE 130A Brushless ESC Manuel D'utilisation page 5

ESC Calibration Procedure
Ensure proper ESC function by calibrating the
ESC to your transmitter inputs.
1. Power off the ESC.
2. Ensure your transmitter is powered on, throttle
is not reversed, throttle trim is neutral and
throttle travel range is at 100%. Disable any
special functions such as ABS, etc.
3. Press the SET button while powering on the
ESC. Release the button as soon as the red
LED starts to flash.
ESC Functions and Modes
The Fuze ESC includes programming options so you can adjust the way your vehicle performs. Refer to
the included settings table to adjust the ESC for your driving conditions.
ESC Programming Procedure
Programming can be accomplished using the
SET button on the on/off switch or Digital
Program Box (DYN3748).
Programming the ESC
1. Connect a battery to the ESC.
2. Power on the ESC using the ESC switch.
3. Hold the SET button for 1 second until the
green LED blinks, then release the SET button
to enter programming mode.
4. Press and release the SET button as needed
to get to the desired menu option (the Green
LED will blink corresponding to the menu
item number). Programming menu items 1
through 9 are accessible using the SET button
on the ESC. Programming menu items 10 and
above are only accessible using the optional
ESC programming card. Programming of
menu items 10 and 11 is only possible after
firmware updates to the ESC programming
card.
4. Calibrate the throttle points by pressing the
SET button once after each step.
• N eutral point (1 flash) - leave the throttle at
rest, untouched
• F ull throttle (2 flashes) - pull the throttle
fully back
• F ull brakes/reverse (3 flashes) - push the
throttle fully forward
5. The motor will run 3 seconds after the last
step is completed.
Tip: If the motor turns in the wrong direction,
reverse the connection of any 2 motor wires.
5. When at the desired menu item, press the SET
button for 3 seconds until the red LED blinks.
6. Press the SET button to move among the
settings based on how many times the red
LED blinks (Refer to the table for more
information).
7. Save the setting by pressing the SET button
for 3 seconds.
8. Power off the ESC switch and repeat
instructions above to change other settings.
Tip: If desired, the ESC programming can be
returned to default settings by powering on the
ESC switch and pressing the SET button for 5
seconds.
EN
5