Philips AT900 Série Mode D'emploi page 13

storage
- Put the protection cap on the shaver to prevent damage.
- AT940/AT893/AT891/AT890 only: Store the shaver in the pouch
supplied.
replacement
For maximum shaving performance, we advise you to replace the shaving
heads every two year. Replace damaged shaving heads right away.
Only replace the shaving heads with original HQ9 Philips Shaving Heads
(AT940) or HQ8 Philips Shaving Heads (AT893/AT891/AT890/AT754/
AT753/AT752/AT751/AT750).
1 Disconnect the shaver from the mains.
2 Press the release button to open the shaving unit.
3 Pull the shaving unit off the shaver.
4 Turn the lock anticlockwise (1) and remove the retaining frame (2).
5 Remove the shaving heads and place new ones in the shaving unit.
Make sure that the projections of the shaving heads fit exactly into the
recesses.
6 Put the retaining frame back into the shaving unit and turn the lock
clockwise.
7 Insert the lug of the shaving unit into the slot in the top of the shaver
(1). Then close the shaving unit (2).
Note: If the shaving unit does not close smoothly, check if you have inserted
the shaving heads properly and if the retaining frame is locked.
ENgLIsh
13