Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CAUTION:
After adjusting the depth of cut, always tighten the
•
lever securely.
Loosen the lever on the depth guide and move the base
up or down. At the desired depth of cut, secure the base
by tightening the lever.
For cleaner, safer cuts, set cut depth so that no more
than one blade tooth projects below workpiece. Using
proper cut depth helps to reduce potential for dangerous
KICKBACKS which can cause personal injury.
Bevel cutting
1
2
009225
Loosen the lever on the bevel scale plate on the front of
the base. Set for the desired angle (0° - 51.5°) by tilting
accordingly, then tighten the lever securely.
Use the 45° stopper when you do precise 45° angle
cutting. Turn the stopper counterclockwise fully for bevel
cut (0° - 45°) and turn it clockwise for 0° - 51.5° bevel
cuts.
0-45°
1
009226
Sighting
A
B
009227
For straight cuts, align the A position on the front of the
base with your cutting line. For 45° bevel cuts, align the
B position with it.
1. Bevel scale
plate
2. Lever
0-51.5°
1. Stopper
1. Base
1
Switch action
009228
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Hex wrench storage
2
009327
Hex wrench is stored on the tool. To remove hex wrench,
rotate it toward yourself and pull it out.
To install hex wrench, place it on the grip and turn it until
it comes into contact with the protrusion on the grip.
Removing or installing saw blade
1
009229
7
1. Switch trigger
1
1. Grip
1
2. Hex wrench
1. Shaft lock
2. Hex wrench
2
Publicité
Table des Matières
