Explanations Of Symbols And References; Symbol Used On The Machine; Symbols Used In The Operating Instructions; Delivery Checklist - Hettich EBA 21 Mode D'emploi

EN
•
Any rotors, hangers or accessories showing clear signs of corrosion or mechanical defects must not be used for
centrifuging.
•
Repairs must only be carried out by personnel authorised to do so by the manufacturer.
•
Only original spare parts and original accessories licensed by the Hettich company are allowed to be utilised.
•
This centrifuge is classified in Germany as a Group 3 device according to the Medizinische Geräteverordnung
MedGV (the regulations on medical equipment).
•
It conforms to safety regulations based on: IEC 61010-1, IEC 61010-2-020
•
The safe operation and reliability of the centrifuge can only be guaranteed if:
− the centrifuge is operated in accordance with the operating instructions,
− the electrical installation on the site where the centrifuge is installed conforms to the demands of IEC
stipulations,
− prescribed tests to BGV A1, BGR 261are carried out by an expert.
•
With centrifuges for robotic use please pay attention to the notes of the key operated switch.
No claim under guarantee will be considered by the manufacturer unless the above instructions have been
adhered to.
4

Explanations of symbols and references

4.1

Symbol used on the machine

Attention, general hazard area.
Before using the centrifuge implicitly read the operating instructions and pay attention to the safety
relevant references!
4.2

Symbols used in the operating instructions

This symbol refers to important circumstances.
This symbol refers to safety relevant warnings and indicates possibly dangerous situations.
The non-adherence to these warnings can lead to material damage and injury to personal.
5

Delivery checklist

1 Connecting cable
1 Hex. pin driver
1 Operating instructions
1 Notes on moving the equipment safely
The rotor(s) and associated accessories are included in the delivery in the quantity ordered.
20/58