Spare Parts - Heiniger Xpert 2 Mode D'emploi

Malfunction
Motor runs very slowly.
Clipper is cutting
poorly or not at all.
Motor unit heats up.

8 Spare parts

See spare parts list at the end of this manual.
Incorrect or defective spare parts can lead to damage, malfunction and complete
failure and can jeopardise safety.
► Use only original spare parts from the manufacturer. Obtain spare parts from an
authorised dealer or directly from the manufacturer.
► If non-approved parts are used, all warranty, service, compensation and liability
claims against the manufacturer or its employees, dealers and representatives will be
forfeited.
34
Possible cause
Clipping blades not lubricated
adequately.
Motor and/or electronics
defective.
Cutting blades are dull.
Clipping blades are not
properly sharpened.
Clipping pressure too low.
Shearing blade is incorrectly
installed and/or aligned.
The animal's hair is too wet.
Hairs are stuck between upper
and lower blade.
Air filter clogged.
Clipping pressure too high.
Defective bearing.
CAUTION
NOTE
Corrective measure
Lubricate the clipping blades.
Notify customer service.
Notify customer service.
Increase the clipping pressure
by turning the adjusting knob as
described in chapter 6.2.
Correctly install the shearing
blade, as described in chapter
6.5. Align the clipping blades
correctly, see Fig. 10.
Only clip dry hair.
Remove the clipping blades;
clean, lubricate and install them
again; set the clipping pressure.
Clean or replace the air filter.
Reduce the clipping pressure.
Notify customer service.
Sheep shearing machine Xpert