Switching The Clipper On And Off; Using The Clipper; Replacing The Clipping Blades - Heiniger Xpert 2 Mode D'emploi

6.3 Switching the clipper on and off

I
Fig. 4

6.4 Using the clipper

Approach the animal from the front.
‹
Secure the animal to be clipped and calm it down.
‹
Plug the power plug into the socket.
‹
Switch the clipper on while you are in the visual range of the animal.
‹
Observe the animal's behaviour while clipping.
‹
Switch the clipper off after you have finished clipping and pull the plug from the socket.
‹

6.5 Replacing the clipping blades

Fig. 5
Sheep shearing machine Xpert
0
To switch the clipper on, slide the ON/OFF
‹
switch to the position I.
To switch the clipper off, slide the ON/OFF
‹
switch to the position 0 (see Fig. 4)
Switch the clipper off by sliding the switch to
‹
the position "0".
Pull the plug from the socket.
‹
Turn the adjusting knob in the direction of the
‹
arrow until the resistance decreases.
Place the clipper with the comb plate screws
‹
facing up onto a flat surface.
29