Setting The Max Volume; Setting The Turn On Volume - Yamaha Digital Sound Projector YSP-3000 Mode D'emploi

Adjusting the system parameters

Setting the MAX VOLUME

You can set the maximum volume level so that this unit
will not output sound beyond the limited volume level.
1
Repeat steps 1 to 3 in "Using the system
parameters" on page 88.
2
Set the operation mode selector to YSP.
"
TV/AV
YSP
3
Press / so that "MAX VOLUME SET" is
displayed in the front panel display.
4
Press ENTER.
90
En
ENTER
ENTER
5
Press / to adjust the maximum volume
level.
Control range: MAX, 99 to 01, MIN
Control step: 1
6
Press STANDBY/ON on the remote control to
set this unit to the standby mode.
STANDBY/ON
The new setting for the maximum volume level will
be activated when you turn on the power of this unit
next time.

Setting the TURN ON VOLUME

You can set the initial volume level when the power of this
unit is turned on.
1
Repeat steps 1 to 3 in "Using the system
parameters" on page 88.
2
Set the operation mode selector to YSP.
TV/AV
YSP
ENTER