EINHELL HS1300 Mode D'emploi page 7

Anleitung HS 1300_SPK1 30.03.2006
1. Description
1. Handle
2. Nameplate
3. On/Off switch
4. Interlock button for On/Off switch
5. Locking lever for cutting depth setting
6. Power cable
7. Splitter
8. Hinged guard hood
9. Screw
10. Shoe
11. Flange
12. Saw blade
13. Parallel stop
14. Lock screw for the parallel stop
15. Lock screw for mitre cuts
16. Dust extractor connection
17. Additional handle
18. Actuator for the hinged guard hood
Please read these instructions carefully and pay
particular attention to the safety regulations. Keep
the instructions together with the circular saw.
2. Technical data
Voltage 230 V ~ 50 Hz
Power rating
Idle speed
Cutting depth at 0°
Cutting depth at 45°
Saw blade 185 mm dia.
Saw blade mount 16 mm dia.
Saw blade thickness
Sound pressure level LPA 91 dB(A)
Sound power level LWA 104 dB(A)
Vibration a
W
Weight
Totally insulated
3. Applications
The hand-held circular saw is designed for sawing
straight cuts in wood, in materials similar to wood,
and in plastics.
4. Safety regulations
The corresponding safety information can be found
in the enclosed booklet.
15:33 Uhr Seite 7
5. Working with the hand-held
circular saw
Always hold the circular saw firmly.
The hinged guard hood will be pushed back
automatically by the workpiece.
Never apply force! Advance the circular saw
gently and steadily.
The off-cut piece should be to the right of the
circular saw so that the wide part of the base
plate is supported over its entire surface.
When sawing along a marked line, guide the
circular saw along the corresponding groove.
Clamp small pieces of wood securely before
sawing. Never hold them in your hand.
Always observe the safety regulations! Wear
goggles!
Do not use defective saw blades or blades with
cracks or flaws.
Do not use flanges or flange nuts with a hole
which is larger or smaller than that of the saw
blade used.
Do not try to stop the saw blade with your hand
or by applying pressure to the side of the blade.
The hinged guard must not jam and must return
to its original position once work is completed.
Before plugging in the circular saw, check that
the hinged guard is functioning properly.
1300 W
Before each use, always check that the safety
4500 rpm
devices - the hinged guard, splitter, flanges and
adjustment devices - are functioning properly and
65 mm
have been adjusted and secured correctly.
46 mm
You can connect a suitable dust extractor to the
guard hood. Check that the dust extractor is fitted
securely and properly.
The hinged guard hood is not to be wedged in
2,4 mm
the retracted guard hood when sawing.
Parallel cuts (Fig. 3)
Important! Wear ear muffs and goggles.
< 2,5 m/s 2
1. Release the lock screw 1.
4,2 kg
2. For 90° cuts, adjust the parallel stop 2 using the
scale on groove A, for 45° cuts adjust the parallel
II/®
stop 2 using the scale on groove B. Observe the
saw blade width.
3. Tighten the lock screw.
Important! First make a trial cut.
Adjustment of the cutting depth (Fig. 4)
1. Release the locking lever 1.
2. Swing the shoe downwards.
3. Adjust the cutting depth using the scale.
The saw teeth must project approx. 2 mm out of
the wood.
GB
7