Panasonic ES8228 Manuel D'utilisation page 9

Cleaning with the self-cleaning recharger (continued)
Do the following if the status lamp blinks or glows during the
"Clean/Dry/Charge" course or the "Clean/Dry" course.
Blinks Glows
Correctly set the Remove the shaver from the self-cleaning
detergent cartridge recharger and then check that the [CLEAN]
and then restart a lamp has gone out. (Be careful as the
course. blade may be hot or wet.) Check that the
water tank is correctly attached, the water
tank cap is securely closed and the self-
If the status lamp
cleaning recharger is placed horizontally.
goes out
Continue a course.
When an abnormality has
been corrected
Press and hold [SELECT] for
approximately 2 seconds to
turn off the status lamp and
then restart a course.
When the status lamp goes
out
Continue a course.
When no abnormality was
found
It is time to replace the
detergent cartridge and
cleaning liquid inside the water
tank.
Drain the old cleaning liquid
inside the water tank and then
refill it with water. Replace the
old detergent cartridge and
then restart the course.
When the status lamp glows
again
Contact an authorized service
center.
Cleaning the shaver without the self-cleaning
recharger
3
4
6
We recommend to clean your
shaver with the self-cleaning
recharger or the "sonic" vibration
cleaning when appears in the
LCD panel.
1. Disconnect the power cord
from the shaver.
2. Apply some hand soap to the
outer foil.
3. Press the On/Off switch for
more than 2 seconds to
activate the turbo mode for
"sonic" vibration cleaning.
• appears in the LCD panel.
• After about 20 seconds, it will
be automatically turned off,
or you can turn it off by
pressing the On/Off switch.
4. Remove the system outer foil
and press the On/Off switch
for more than 2 seconds to
activate the turbo mode for
"sonic" vibration cleaning and
clean it with running water.
5. Wipe off any drops of water
with a dry cloth.
6. Remove the system outer foil
to allow it to dry completely.
9