Installation And Commissioning; Montage - Burkert PTB 03 ATEX 5014 X Instructions De Service

INSTALLATION AND COMMISSIONING

Montage

The Type 641, 2832, 6013 and 6022 units may only be installed in petrol pumps
between the pump valve and the gas feedback pump. This use must be based
on DIN VDE 0165.
Please observe the maximum permissible environmental temperature range.
ATTENTION
ATTENTION
Clean the pipe runs
Installation in any position
16 - 03 ATEX5014 X
In areas with an explosion hazard, the surface of the units
may only be cleaned with a damp cloth!
The connecting cables to the electromagnets must be
secure, and be laid so that they are adequately protected
from mechanical damage.
Only open the terminal box when it is disconnected from the
electrical power!
Preferred direction