Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Control Panel

• Best results are obtained by using a low speed for normal
conditions and a high speed when odours are more concentrated.
Turn the hood on a few minutes before you start cooking.
The hood should be left on after cooking for about 15 minutes or
until all the odours have disappeared.
The control switches are located on the unit's front panel:
1
2
1. Light ON/OFF key
2. Suction speed (power) ON/OFF key
Note: pressing this key, the hood restores the last suction speed
(power) selected before being switched off.
3. Filters saturation reset indicator key: press the key for several
seconds to reset the filters saturation indicator.
Attention! This operation should be performed ONLY after having
carried out the maintenance of the filters.
4. Display - shows:
Suction speed (power)
Fat filters saturation: the letter F appears on the display
Carbon filter saturation: the letter C appears on the display
Note: the letter C appears even if the filter has not been installed
(functioning of the hood in the suction version); in any case press
key 3 as described above to carry out resetting.
Timer activated: the letter "t" appears on the display
5. Increase suction speed (power) key
6. Decrease suction speed (power) key
7. Timer ON/OFF: pressing this key, any suction speed (power)
selected will continue to function for 5 minutes, after which the hood
will switch off. Press key 5 or 6 to exclude the Timer before end.
3
4
5
6
7
55

Publicité

Table des Matières
loading

Table des Matières