IKA KS 130 basic Mode D'emploi page 25

Masquer les pouces Voir aussi pour KS 130 basic:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

After the power has been turned off, the device will automatically start
up in operating mode C by itself.
After you have selected operating the mode and turned on
the device, the folling process will be shown on the display.
a.) All display elements in the digital displays are activated for about 2
seconds.
b.) The device type (left display) and operating mode (right display) are
displayed for about 2 seconds.
I 3 0
K S
c.) The set time target value (for example 3:58) is displayed with
the indication h min and SV .The set (or stored) upper speed limit
from operating mode A is displayed with SAFE and OK for about 2
seconds. The display upper speed limit cannot be modified by pressing
and turning the turn button.
d.) The new speed target value that has been set or just stored in the
2 3 0
S A F E
O K
left display (for example 130) from operating mode A or B is then
shown with the unit 1/min and flashing SV .
e.) By pressing the left or right turn button, you can place the agitator
in operation. The speed and time values are then shown in large for-
mat on the display. In addition, the text PV is shown on the display
instead of SV .
The actual value of the time setting must be understood from this
point onward as the time remaining for the agitation process. If the
time remaining has reached zero, the agitator stops its motion.
I 3 0
C
Switching the operation mode:
The following steps are required to switch the operating mode:
,
a.)
Turn off the device with the power switch.
b.)
Hold down both turn buttons and turn on the device
with the power switch. After about 1 second, you can
let go of the turn buttons.
c.)
It is not possible to switch between operating modes A, B
and C in any order.
Instead, you can only switch by repeating the steps above
A - step a.) + b.) >B - step a.) + b.) >C - step a.) + b.)>
3 5 8 :
A - step a.) + b.) >
i
n
m i n
Setting the audio time expiration signal
SV
,
The following steps are required to activate the audio time expiration
signal:
I 3 0
I
/
m i n
SV
SV
3 5 6 .
I 3 0
I
/
m i n
PV
3 5 8 :
i
n
m i n
,
3 5 8 :
i
n
m i n
PV
,
25

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ks 130 control

Table des Matières