Electronic Oven Control; Display; Start; Off/Cancel - Whirlpool 9757455 Guide D'utilisation Et D'entretien

A. Oven display
B. Timer functions
C. Clock
D. Oven light

Display

When power is first supplied to the appliance, everything on the
display will light up for 1 to 2 seconds, then the time of day and
"PF" will appear. Press OFF/CANCEL to clear "PF" from the
display.
If "PF" appears at any other time, a power failure has occurred.
Press OFF/CANCEL and reset the clock if needed.
When the oven is in use, the display shows preheat time and the
temperature and oven setting.
When the oven is not in use, the display shows the time of day.
When using the TIMER, for settings of 1 to 59 minutes, the
display will count down in seconds. For settings 1 hour or over,
the display will count down hours and minutes.
When using COOK TIME, the display will show hours and
minutes. When using STOP TIME, the display will show minutes
and seconds.
After setting a function, you must press the START button to start
the function. If you do not press the START button within
5 seconds, "START?" will be displayed as a reminder.

Off/Cancel

The OFF/CANCEL button stops any function except the Clock,
Timer and Control Lock. When you press the OFF/CANCEL
button, the display will show the time of day, or the time
remaining if the TIMER is being used.
8

ELECTRONIC OVEN CONTROL

E F
E. Oven settings
F. Temperature adjustment
G. Auto clean
H. Timed cooking

Start

A
G H
On some models, if you do not want the clock time to be
displayed, press and hold the CLOCK pad (button) for 5 seconds.
When the clock is not displayed, you can see the time for
5 seconds by pressing the CLOCK pad (button).
To Set:
Before setting, make sure the oven, TIMER and COOK TIME are
off.
1. Press CLOCK.
2. Press the HOUR and MIN "up" or "down" arrow pads
(buttons) to set the time of day.
3. Press CLOCK or START.
Tones are audible signals which indicate that a function has been
entered correctly, or when a cycle has ended.
To shut off all tones except the end-of-timer and error

tones:

1. Press and hold the STOP TIME button for 5 seconds.
2. A short tone will sound when the tones have been changed.
To turn tones back on, repeat Step 1.
3. "Off" will be displayed for 3 seconds when the tones have
been turned off, and "ON" will be displayed for 3 seconds
when the tones have been turned back on.
B C D
I J K
I. Hour and minute
J. Start and control lock
K. Off/cancel

Clock

Tones