Transport And Connection - Aerial AD 740 Série Mode D'emploi

9

Transport and connection

Transport
WARNING! Crushing as a result of in-
stability!
Transport the dehumidifier in an up-

right position and secure it so that it
cannot tip over or slip.
Position the dehumidifier on a sta-

ble, even surface.
WARNING! Crushing or cutting from
reaching into the grille of the air filter!
Use the handles to transport the

dehumidifier.
Do not reach into the air filter.

CAUTION! Crushing or ergonomic
damage when transporting the dehu-
midifier!
Use the handles to transport the de-

humidifier.
The dehumidifier must be trans-

ported by two people.
Procedure
1. Make sure that the basin is empty
and secured with the basin lock.
2. Make sure that the discharge hose
(optional) and the mains cable have
been disconnected from the appli-
ance.
3. AD 740: Raise the hinged handle
for transporting on the wheels. To
do this, release the lock on the right
and left of the hinged handle (item
1) and lift the hinged handle until
the lock engages again.
4. Transport the dehumidifier to where
it is going to be used.
AD 740: Fold the hinged handle
5.
back down again.
NOTE: The air must circulate freely. Do
not cover the air openings. There must
be a clearance of at least 1 m in front of
the air outlet and the air filter.
Preparing the basin
Does not apply if an optional discharge
hose is connected.
Procedure
Slide the basin into the dehumidi-

fier.
Secure the basin with the basin

lock.
Connecting an optional discharge
hose
If necessary, the condensate water can
be drained off via a discharge hose in-
stead of into the basin. To do this, pro-
ceed as follows:
ATTENTION! Inadequate appliance
output!
Do not place the end of the hose in

the water (backwater possible).
Do not bend the discharge hose.

Do not place any objects on the

hose.
Procedure
1. Remove the basin.
2. Attach a suitable hose (12 x 2 mm)
to the discharge nozzle (Pos. 2) us-
ing a pipe clip.
19
2