Decommissioning, Storage And Disposal - Aerial AD 740 Série Mode D'emploi

Faults
Problem
The dehumidifier is
not performing
well/removing mois-
ture.
The dehumidifier is
out of operation / fan
and compressor are
not working.
"Basin full" illuminates
even though the basin
is empty.
Pump fault.

13 Decommissioning, storage and disposal

Decommissioning
Procedure
1. Switch off the dehumidifier.
2. Empty the basin.
3. Unplug the mains plug.
4. Cover the dehumidifier with a cloth
to protect it from dust.
Storage
WARNING! Injury!
Do not stack more than two dehu-

midifiers on top of each other. Make
sure that the feet of the top appli-
ance are in the notches of the bot-
tom appliance.
Possible cause
Air filter is dirty. The
dehumidifier is not
getting enough air.
Dirty filters can dam-
age the appliance in
the long term.
Dehumidifier is swit-
ched off.
There is no power
supply to the dehu-
midifier.
Basin not inserted
correctly.
Pump is blocked, e.g.
water cannot drain
out of the discharge
hose/basin.
Pump faulty.

Procedure
1.
23
Remedial action
Clean the filter or replace if
necessary.
Switch on the dehumidifier.
Check the power supply.
Insert basin correctly.
Check the discharge hose/ba-
sin, if connected.
Contact AERIAL Service.
Secure the dehumidifiers to prevent
them from tipping over or falling,
e.g. using tension belts.
Store the dehumidifier between 0 °C
and +40 °C.