Agu Tomchi N8 Mode D'emploi page 133

a. The value of the electromagnetic force generated by stationary transmitters,
such as base stations of mobile phones and mobile radio systems, amateur radio
transmitters, AM and FM radio transmitters and television transmitters, cannot be
exactly determined theoretically. To assess the possible impact of such a trans-
mitter, it is necessary to carry out electromagnetic measurements on site. If the
measured values of the electromagnetic field at the site of use of the AGU N8
exceed the corresponding permissible level, it is necessary to check the correct
operation of the AGU N8. If the device does not operate normally, additional
measures may be taken, such as changing the orientation of the AGU N8 or its
location.
b. In the frequency range 150 kHz - 80 MHz, the field force values should be less
than 3 V/m.
The recommended minimum distance between portable and mobile radio
equipment and the device - for a device, that is not a LIFE SUPPORT DEVICE!
The recommended minimum distance between portable and mobile radio
equipment and the device.
The device is intended for use in an electromagnetic environment in which the
level of emitted high-frequency interference is monitored. Users or purchas-
ers of the device can help prevent the occurrence of electromagnetic interfer-
ence by observing the minimum permissible distances between the portable or
mobile high-frequency communication equipment (transmitter) and the device,
as recommended below, depending on the maximum emanation power of the
communication equipment.
Nominal maximum
emanation power of
the transmitter (W)
0,01
0,1
1
10
100
For transmitters with nominal maximum emanation power not specified above,
the recommended minimum distance d in meters (m) can be estimated using
the appropriate transmitter frequency of the equation, where P is the maximum
transmitter power in watts (W) according to the transmitter manufacturer's data.
EN
The minimum distance, depending on the frequency of the
transmitter (M)
150 kHz – 80 MHz
80 MHz - 800 MHz
d = 1,2√P d = 1,2√P
0,12 0,12
0,38 0,38
1,2 1,2
3,8 3,8
12 12
800 MHz – 2,5 GHz
d = 2,3√P
0,23
0,73
2,3
7,3
23
133