Intended Use - Ayce PN3800 Notice Originale

BEWARE OF: ROTATIONAL KICKBACK (Fig. 2A)
A = Kickback path
B = Kickback reaction zone
THE PUSH (PINCH KICKBACK) AND PULL REACTIONS (Fig. 2B)
A = Pull
B = Solid objects
C = Push
Maintain a firm grip, with thumbs and fingers encircling the chain saw handles, with both hands
on the saw and position your body and arm to allow you to resist kickback forces. Kickback forces
can be controlled by the operator, if proper precautions are taken. Do not let go of the chain saw.
Do not overreach and do not cut above shoulder height. This helps prevent unintended tip contact
and enables better control of the chain saw in unexpected situations.
Only use replacement bars and chains specified by the manufacturer. Incorrect replacement bars
and chains may cause chain breakage and/or kickback.
Follow the manufacturer's sharpening and maintenance instructions for the saw chain.
Decreasing the depth gauge height can lead to increased kickback.

INTENDED USE

The chain saw is intended for sawing of trees, tree trunks, branches, wooden beams, planks,
etc. Cuts can be sawed with or across the grain. This product is not suitable for sawing mineral
materials.
Noise Information
Measured sound values determined according to ISO 22868.
The noise figures quoted are emission levels and are not necessarily safe working levels. Whilst
there is a correlation between the emission and exposure levels, this cannot be used reliably to
determine whether or not further precautions are required. Factors that influence the actual level
of exposure of work-force include the characteristics of the work room, the other sources of noise,
etc. i.e. the number of machines and other adjacent processes, and the length of time for which an
operator is exposed to the noise. Also the permissible exposure level can vary from country. This
information, however, will enable the user of the machine to make a better evaluation of the hazard
and risk.
Wear hearing protection!
Vibration total values (triax vector sum) determined according to ISO 22867:
The vibration emission level given in this information sheet has been measured in accordance with
a standardized test given in ISO 22867:2003 and may be used to compare one tool with another.
It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main applications of the tool. However if the
tool is used for different applications, with different accessories or poorly maintained, the vibration
emission may differ. This may significantly increase the exposure level over the total working
period.
An estimation of the level of exposure to vibration should also take into account the times when
the tool is switched off or when it is running but not actually doing the job. This may significantly
reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator from the effects of vibration such as:
maintain the tool and the accessories, keep the hands warm, organization of work patterns.
ASSEMBLY
Installing guide bar and saw chain
Open the box and install the guide bar and the saw chain on the power unit as follows.
WARNING!
The saw chain has very sharp edges. Use protective gloves for safety.
The saw chain and bar are packed separately in the carton.
Chain and guide bar
Use only the guide bar (13) and saw chain (14) according to the technical data of the product.
1. Set the product on a suitable flat surface.
2. Before removing, ensure the chain brake is disengaged. If in the engaged position, pull the
front hand guard/brake lever (11) backwards until it 'clicks' into position.
3. Use the provided spark plug wrench (32) to remove the two retaining nuts (16) from the side of
the cover (18).
4. If necessary adjust the tension pin (22b) by moving the tension screw (22a) with the
screwdriver (33) in or out until it reaches a position where the pin can be inserted into the
lower hole on the guide bar (13) (Fig. 3).
5. The guide bar (13) should be fitted with the saw chain 'cutter' symbol at the top of the bar (Fig.
4).
138 139 GB