Weather Forecast - Hama Premium HX075-0501200-AG-001 Mode D'emploi

Hinweis – Snooze function
• While the alarm signal is sounding, press the " /
button (B1) to activate the snooze function. The alarm
signal will stop for 5 minutes, after which it will sound
again.
• Press any button (except the " /
the snooze function and the alarm.

6.4 Weather forecast

• Based on changes in the atmospheric pressure and the data
saved, the base station is able to make weather forecasts for
the next 12 to 24 hours.
Note – Weather forecast
The weather forecast function is not available during the
first few hours of operation because it requires data that is
collected during operation.
The weather station shows the trend of the weather for the
next 8 hours using the following weather symbols:
Symbol
6.5 Temperature, humidity and atmospheric pressure
trends
Note
The trend displays are not available during the first few
hours of operation because they require data that is
collected during operation.
Note
All measurement values are subject to a certain amount of
measurement error.
6
"
" button, B1) to stop
Weather
Sunny
Slightly cloudy
Cloudy
Rainy
Very rainy
Snow
The weather station indicates a trend as to how the values for
the outdoor temperature/humidity (A1/A2), room temperature/
humidity (A10/A8) and atmospheric pressure (A6) are likely to
develop over the next few hours.
Display
Unit of air pressure
• Press and hold the " " button (B7) for approx. 3 seconds
until the measurement unit of the air pressure starts to flash.
• Press the " " button (B4) and the " " button (B5) to switch
between the units "mb hPa" and "inHg".
• Press the " " button (B7) to confirm your selection.
Air pressure record
• The air pressure recorded in the last 24 hours is displayed
(A7).
6.6 Maximum and minimum temperature and humidity
values
• The base station automatically stores the maximum and
minimum outdoor/indoor temperature and humidity values.
• Repeatedly press the MEM button (B8) briefly to switch
between the current temperature and humidity, minimum
temperature and humidity (MIN) and maximum temperature
and humidity (MAX).
• Press and hold the MEM button (B8) for approx. 3 seconds
to reset the stored maximum and minimum values.
6.7 Comfort display
The base station displays the following comfort ranges based
on the ration between the current room temperature and room
humidity:
Display (A9)
Trend
Increasing
Constant
Decreasing
Comfort range
Very comfortable
Comfortable
Somewhat too cool or warm /
Somewhat too dry or humid
Too cold or hot /
Too dry or humid
Much too cold or hot /
Much too dry or humid