Temperature Trend; Weather Forecast; Backlight - Hama EWS-3100 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
• When the alarm is triggered, the
(11) begins to flash and an alarm sounds.
• Press any button (except SNOOZE/LIGHT sensor (28)) to
stop the alarm. Otherwise, it will stop automatically after
2 minutes.
Note – Snooze function
• While the alarm signal is sounding, press the SNOOZE/
LIGHT sensor (28) to activate the snooze function. Zz (14)
will begin to flash on the display. The alarm signal will
stop for 5 minutes, after which it will sound again.
• Press any button (except the SNOOZE/LIGHT sensor
[28]) to stop the snooze function and the alarm.

6.3. Weather forecast

• Based on changes in the atmospheric pressure and the
data saved, the base station is able to make weather
forecasts for the next 12 to 24 hours.
ote – Weather forecast
N
The weather forecast function is not available during the
first few hours of operation because it requires data that is
collected during operation.
• The weather forecast and the current weather are indicated
by five different symbols (1):
Symbol (1)
6
active alarm symbol
Weather
Sunny
Slightly cloudy
Cloudy
Rainy
Stormy

6.4. Temperature trend

Note – Temperature trend
The temperature trend display is not available during the
first few hours of operation because it requires data that is
collected during operation.
• The weather station indicates a trend as to how the values
for the outdoor temperature (4) and room temperature (21)
are likely to develop over the next few hours.
Display
6.5. Maximum and minimum temperature
The base station automatically stores the maximum and
minimum outdoor/indoor temperature values.
• Repeatedly press the + button (24) to switch between the
current temperature, maximum temperature (MAX) and
minimum temperature (MIN).
• Press and hold the + button (24) for approx. 3 seconds to
reset the stored maximum and minimum values.

6.6. Backlight

Press the SNOOZE/LIGHT sensor (28) to activate the backlight.
7. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth
and do not use aggressive cleaning agents. Make sure that
water does not get into the product.
8. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.
9. Service and Support
Please contact Hama Product Consulting if you have any
questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
Trend
Increasing
Constant
Decreasing

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

00136257

Table des Matières