Environmental Protection - Ryobi R18ALF Traduction Des Instructions Originales

Masquer les pouces Voir aussi pour R18ALF:

Traduction des instructions originales (76 pages)

Table des Matières

Les langues disponibles

FOLDING AREA LIGHT SAFETY WARNINGS

Know the product. Read user's manual carefully.

Learn its applications and limitations as well as the

specific potential hazards related to the product.

Use only with recommended battery pack and

charger. Any attempt to use another battery pack

will cause damage to the product and could possibly

explode, cause a fire, or personal injury.

Do not disassemble the product.

Do not place the product or battery pack near fire or

heat. This will reduce the risk of explosion and possible

injury.

Do not store the product in a damp or wet location,

or in a location where the temperature may reach

or exceed 40°C (104°F). For example, inside sheds,

vehicles, or metal buildings in the summer.

Check damaged parts. Before further use of the

product, a part that is damaged should be carefully

checked to determine that it will operate properly and

perform its intended function. Do not use the product if

it does not function properly.

Have the product repaired by a qualified person.

The product is in accordance with the relevant safety

requirements. Repairs should only be carried out by

qualified person using original spare parts, otherwise

this may result in considerable danger to the user.

The light source of this luminaire is not replaceable;

when the light source reaches its end of life the whole

luminaire shall be replaced

BATTERY SAFETY WARNINGS

Do not place battery tools or their batteries near

fire or heat. Following this rule will reduce the risk of

explosion and possibly injury.

Never use a battery that has been dropped or

received a sharp blow. A damaged battery is subject

to explosion. Properly dispose of a dropped or damaged

battery immediately.

Batteries can explode in the presence of a source

of ignition, such as a pilot light. To reduce the risk of

serious personal injury, never use any cordless product

in the presence of open flame. An exploded battery

can propel debris and chemicals. If exposed, flush with

water immediately.

Do not charge battery tool in a damp or wet location.

Following this rule will reduce the risk of electric shock.

Do not place batteries near fire or heat. They may

explode.

Risk of electric shock. Do not touch uninsulated portion

of output connector or uninsulated battery terminal.

For best results, your battery tool should be

charged in a location where the temperature is

more than 10°C but less than 38°C. Do not store

outside or in vehicles.

Under extreme usage or temperature conditions,

battery leakage may occur. If liquid comes in

contact with your skin, wash immediately with soap

and water. If liquid gets into your eyes, flush them

with clean water for at least 10 minutes, then seek

immediate medical attention. Following this rule will

reduce the risk of serious personal injury.

ADDITIONAL BATTERY SAFETY WARNINGS

WARNING

damage due to a short circuit, never immerse your

as seawater, certain industrial chemicals, and bleach

or bleach-containing products, etc., can cause a short

circuit.

TRANSPORTING LITHIUM BATTERIES

Transport the battery in accordance with local and national

provisions and regulations.

Follow all special requirements on packaging and labelling

when transporting batteries by a third party. Ensure that

no batteries can come in contact with other batteries

or conductive materials while in transport by protecting

exposed connectors with insulating, non-conductive caps

or tape. Do not transport batteries that are cracked or

leaking. Check with the forwarding company for further

advice.

MAINTENANCE

When servicing, use only original RYOBI replacement

parts. Use of any other parts may create a hazard or

cause product damage.

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types

of commercial solvents and may be damaged by their

use. Use clean cloths to remove dirt, dust, oil, grease,

etc.

Do not attempt to modify the product or create

accessories not recommended for use with the product

by the manufacturer.