Maintenance And Precautions For Use; Decontamination Program - Ugin ARTIS NEO Mode D'emploi

Instructions for use (rev 290319)

9. MAINTENANCE AND PRECAUTIONS FOR USE

To maintenance work and/or cleaning, ARTIS NEO must be disconnected from the main
power supply, and at room temperature: wait the cooling after use (risk of burns and/or
damage)
Except for cleaning the machine outside, ARTIS NEO furnace maintenance entails only two other
operations:
- Cleaning the platform sealing joint regularly with alcohol
- Replacing the muffle after 3000 hours of service
Recommendation:
- For press the control panel keys never use metal or very hot instruments which would
damage the plastic film
- Clean the panel with a solvent-free product
- Keep hot pieces away from the panel to avoid the risk of damage by heat radiation
- Leave the furnace hooked up at all times, except during prolonged absence
- Clean the machine outside with a soft, dry cloth
- Do not introduce stranger objects inside the unit during the maintenance operations
- Do not spill liquid on the ventilation openings or inside the furnace: risk of electric shock

9.1. Decontamination program

Carry out regular decontamination program:
 Set the program parameters as follows:
- Pre-drying temperature = 700°C
- Platform rise time
- Internal pre-drying
- Vacuum start
- Vacuum stop
- Vacuum level
 Then place the "CARBONET" decontamination graphite on the base
 Initiate the cycle by pressing the key
UGIN DENTAIRE
- Vacuum hold time
= 0 min - Heat-rise rate
= 0 min - Final temperature
= 700°C - Hold time
= 1030°C - Internal cooling
= 94% - Platform lowering
ARTIS NEO
= 2 min
= 100°C/min
= 1040°C
= 4 min
= 2 min
= 0 min
33