Tape Playback; Basic Operations - Aiwa XH-A1000 Mode D'emploi

TAPE PLAYBACK

BASIC OPERATIONS

REV MODE
DOLBY NR
zTAPE
OPEN/
CLOSE
Cassette
tray
TAPE
a
s
1 Press DOLBY NR to turn Dolby NR on or off to
match the playback tape.
hNR
For tapes recorded with DOLBY NR, turn on hNR.
For tapes recorded without DOLBY NR, turn off hNR.
2 Press TAPE and press zTAPE OPEN/CLOSE to
open the cassette tray.
zTAPE OPEN/CLOSE
Cassette tape
Load a tape with the exposed side facing the unit, and the
side to be played back facing upward.
3 Press zTAPE OPEN/CLOSE to close the cassette
tray.
4 Press d to start play.
To play the opposite side of the tape, press d again.
Playback
The tape counter indicates the tape
running length.
side indicator
x: The side facing upward is being played (forward).
c: The opposite side is being played (reverse).
16
ENGLISH
To stop play, press s.
To pause play, press a. To resume play, press again.
To fast forward or rewind, press f or g. Then press s
to stop the tape.
Types of tape
Use Type I (normal), Type II (high/CrO
for playback.
To select a reverse mode
Each time REV MODE is pressed, the reverse mode changes.
f,g
jl
To play one side only, select p.
To play from the side facing upward to the opposite side once
only, select
To play both sides repeatedly, select ].
To start play when the power is off (Direct Play Function)
When a tape is loaded, press TAPE. The power is turned on
and playback begins.
When zTAPE OPEN/CLOSE is pressed, the power is also
turned on.
To set the tape counter to "0000"
Press sCLEAR in stop mode.
The counter is also set to "0000" when the cassette tray is
opened.
MUSIC SENSOR
If there is a 4-second or longer blank between each track, a
search for the beginning of the current or next track during
playback can be done easily.
When the x indicator of d is flashing, press f to move
to the next track or g to move to the beginning of the current
track.
When the c indicator of d is flashing, press g to move
to the next track, or f to move to the beginning of the current
track.
The search function may not be able to detect tracks under the
following conditions:
• Blanks of less than 4 seconds between tracks
• Noisy blanks
• Long passages of low-end sound
• Low overall recording levels
) or Type IV (metal) tapes
2
.
] P