Acoustic Signals - AEG FSE62400P Notice D'utilisation

10 www.aeg.com
If you use standard detergent or multi-
tablets without rinse aid, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse
aid empty notification
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
start to flash and the display is blank.
2. Press
• The indicators
off.
• The indicator
flash.
• The display shows the current
setting:
notification is activated (factory
setting).
3. Press
= the rinse aid empty notification is
deactivated.
4. Press the on/off button to confirm
the setting.

6.4 Acoustic signals

Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
and
, , and
.
, and
continues to
= the rinse aid empty
to change the setting.
and
the indicators
start to flash and the display is blank.
2. Press
• The indicators
off.
• The indicator
flash.
• The display shows the current
setting:
–
until
–
3. Press
4. Press the on/off button to confirm
the setting.
go
6.5 AirDry
AirDry improves the drying results with
less energy consumption.
While the drying phase
operates, a device opens the
appliance door. The door is
then kept ajar.
CAUTION!
Do not try to close the
appliance door within 2
minutes after automatic
open. This can cause
damage to the appliance.
AirDry is automatically activated with all
programmes excluding
(if applicable).
To improve the drying performance refer
to the XtraDry option or activate AirDry.
until
, , and
.
, and
continues to
= Acoustic signal off.
= Acoustic signal on.
to change the setting.
and
go