Trimming The Helicopter - Reely Lama 5.1 Notice D'emploi

g) Trimming the helicopter
Push the Pitch stick (see figure 1, Pos. 12) from the bottom position (engine off) carefully forward and observe the
response of your model. Shortly before the helicopter starts hovering, you can already determine in which direction
your model wants to move.
If the helicopter wants to turn to the right with the tip of the fuselage, then reduce the speed and push the steering trim
for the Tail function (see figure 1, Pos. 11) gradually to the left.
Push the Pitch stick carefully forward and check if the adjustment was sufficient.
Keep repeating this procedure until the helicopter no longer has any tendency to turn to the right. If the tip of the
fuselage turns to the left, carry out a right trim adjustment.
If the helicopter wants to turn or to tilt sideways to the right, then reduce the speed and push the steering trim for the
Roll function (see figure 1, Pos. 3) gradually to the left.
Push the Pitch stick carefully forward and check if the adjustment was sufficient.
Repeat the procedure until the model does not show any tendency to drift to the right. If the helicopter wants to drift
sideways to the left, carry out a trim adjustment to the right.
Figure 10
Figure 11
49