3 Embers GAS9675AF Notice D'utilisation page 11

MATCH LIGHTING THE MAIN BURNER:
1 . Open lid before lighting burner .
2 . Make sure all control knobs are "OFF" .
3 . Place a paper match in the end of the matchlighter . Strike match and
place through the cooking grate approximately 1/2" (1 to 2 cm) from
the burner to be lit .
4 . Turn burner control knob to "HIGH" position . The burner should light
within 5 seconds .
5 . If burner does not light, turn control knob to "OFF" and wait 5 minutes for gas to dissipate and repeat
lighting procedure .
6 . Once lit, light adjacent burners by following steps 3-6 .
7 . If burner does not light within first few attempts of match lighting, there is a problem with the gas supply .
Turn off gas at burner and cylinder . DO NOT attempt to operate grill until the problem is found and
corrected .
Note: If burner does not light or flame is too low, See "Trouble Shooting" section of the owners manual .
LIGHTING THE SIDE BURNER:
1 . Open lid before lighting side burner .
2 . Make sure control knob is "OFF" .
3 . Push and hold down side burner control knob and SLOWLY
(2 to 3 seconds) turn to "HIGH" . You should hear the igniter click .
Note: Step 3 may need to be repeated 2-3 times to light side burner .
4 . If ignition does NOT occur in 5 seconds, turn control knob to "OFF" , wait
5 minutes to allow gas to dissipate and repeat lighting procedure .
5 . If burner does not ignite using the igniter, see "Match Lighting the Side
Burner" section .
6 . To turn off, turn control knob clockwise until it locks in "OFF" position .
Note: If burner does not light or flame is too low, See "Trouble Shooting" section of the owners manual .
MATCH LIGHTING THE SIDE BURNER:
1 . Open lid to the side burner before lighting .
2 . Make sure control knob is "OFF" .
3 . Place a paper match in end of the matchlighter . .
4 . Strike match and hold it approximately 1/2" (1 to 2 cm) from burner .
5 . Turn side burner control knob to "HIGH" position . The burner should light within 5
seconds .
6 . If burner does not light, turn control knob to "OFF" and wait 5 minutes for gas to dissipate
and repeat lighting procedure .
7 . If burner does not light within first few attempts of match lighting, there is a problem with the gas supply . Turn off
gas at burner and cylinder . DO NOT attempt to operate grill until the problem is found and corrected .
Note: If burner does not light or flame is too low, See "Trouble Shooting" section of the owners manual .
Note: Observe flame height when lit: Flame should be a Blue/Yellow color between 1"–2" when burner is on
"HIGH" .
See section in manual on burner adjustment to adjust flame.
LIGHTING THE SEAR BURNER:
1 . Open lid before lighting sear burner .
2 . Make sure control knob is in the "OFF" position .
3 . Push and turn burner control knob to "HIGH" position .
4 . Press igniter for 3–5 seconds to light burner .
MATCHLIGHTER
10