INTEGRA Metering CALEC ST II Instructions De Montage Et Mode D'emploi page 93

Option LON Interface
Type
Baud rate
Maximum bus length
Option BACnet MS/TP
Physical layer and
AMT ID
BACnet device profile
and instance
BACnet MAC address
Baud rate and mode
Option N2Open
Physical layer
and address
Baud rate
2 analogue outputs
Output signal
Supply voltage
Electrical isolation
Max. resistance
Max. transformer error
CALEC ST II
®
Factory settings
LON TP-FT 10 free topology (2-wire twisted pair),
certified in accordance with LONMARK
78 kBaud
500 m / 2700 m with/without termination resistors,
64 nodes per segment
Factory settings
RS 485 / ID: 431
B - ASC / the last 5 digits of the serial number
The last 2 digits of the serial number
Automatic / master
Factory settings
RS 485 / address: 1
9600
4...20 mA or 0...20 mA
6...24 V DC
max. 48 V DC
≤ 837 ohms at 24 V DC, 0 ohms at 6 V
0.15% of measured value + 0.15% of end value
3.4
®
93