Location Requirements; Electrical Requirements - Haier AM09AA1TAA Mode D'emploi

11
•
Exhaust pipe assembly
•
Remote Control for
Cooling Only Model

LOCATION REQUIREMENTS

•
Place the air conditioner on a flat level surface in a
location that is at least 51 cm from any wall.
NOTE: A minimum clearance of 51 cm from the air
conditioner to the wall must be maintained to ensure
proper airflow
•
Maintain a minimum 51 cm clearance around the air
conditioner to not block airflow
•
Keep the air conditioner free of any obstructions such as
drapes, curtains, blinds, etc.
•
The exhaust hose should be free of any obstructions.
•
Do not place the air conditioner on an unstable or raised
surface because it could fall and cause damage or injury.
•
Do not place the air conditioner in direct sunlight or near
a heat source such as baseboard heaters, stoves, etc.
•
The window panel can be installed in a window with a
90 cm to a maximum 130cm opening.
•
Screw (2)
1 for extension panels
1 for nozzle
•
Remote Control for
Cooling&Heating
Model
4

ELECTRICAL REQUIREMENTS

WARNING
Electrical Shock Hazard
Plug into a grounded outlet only.
Do not remove the ground contacts from the power
cord plug.
Do not use an adapter.
Do not use an extension cord.
o follow these instructions can result in death,
fire shock.
POWER SUPPLY CORD
Wiring Requirements
•
230 Volt, 50Hz, 16-amp fused grounded outlet
•
The use of a time-delay fuse or time-delay circuit breaker
is recommended.
•
Use a dedicated circuit only.
NOTE: Do not operate any other electrical
appliances on this circuit or you may trip the circuit
breaker/fuse.
If this power supply cord is damaged, it cannot be repaired. It
must be replaced with a cord from the product manufacturer.