Betriebsanleitung für Druckluftenthäuter PLE-10
Cleaning the blade guard
We recommend dismantling the blade guard 2 to 3
times a week to permit still more thorough cleaning of
the machine.
The blade guard can also be dismantled to permit a
general cleaning operation. Proceed as follows:
1. Detach and remove the 6 M3 countersunk screws
using a suitable slotted screwdriver (fig. 27).
Fig. 27
2. Pull the two halves of the blade guard apart
carefully. There is now no obstacle to thorough
cleaning.
3. Before assembling the blade guard halves, make
sure that the support surfaces have been cleaned
carefully to remove all residual dirt (fig. 28).
Fig. 28
Recommended cleaning and disinfecting
agent
Disinfecting solution:
"TEGO-DUR", action time = 20-30 minutes
Maintenance
Warning!
Isolate th
compressed air n
performing maintenance work!
Important!
Maintenance
performed b y authorised sp ecialist
personnel.
To avoid friction and corrosion damage, regular
maintenance and servicing are essential.
Always store the dehider knife in a dry room.
Checking the maintenance unit
To allow the compressed air knife to work perfectly,
the maintenance unit should be checked at regular
intervals. For this purpose, first release the pressure
in the system! Now remove condensate water and if
necessary apply special oil to the oiler.
This will prevent damage to motor parts caused by dirt
or rust particles.
For this purpose
•
Remove the condensed water and
•
Check the operating pressure (max. 8 bars) at
regular intervals.
Repairs
Repairs may only be performe d b y
specialist pers onnel. Our s ervice
department is a t your di sposal for
this purpose.
Use only original spare parts!
Please contact your nearest contractual workshop or
the parent company directly.
The spare parts lists can be issued on request to the
specialist workshops.
If the machine performance deteriorates, the dehider
knife must be dismantled and cleaned. Worn
components
must
GB
e mach
ine fro
m th
etwork b
efore
work may
only
be
always
be
replaced.
22
e