Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Betriebsanleitung für Druckluftenthäuter PLE-10
Adjusting the blade stroke
Important!
An excessi ve stroke
damage to the blade.
Warning!
Never put y our ha nd ne ar the s harp
side of the bl ade othe rwise y ou may
cut yourself badly!
Warning!
Always separate the machine from
the co mpressed air n etwork when
adjusting the stroke!
Important!
Never switch the machine on without
the blade protector in place or with a
loose bla de prote ctor. Th is would
destroy th e b lade an d cr eate a
potential ris k of injury from brok en
blade parts.
Before using the machine, check the stroke and
adjust it if necessary:
•
Remove the finger guard (fig. 13).
•
Let the machine run without the finger guard (6
bars) and check the stroke. The machine is
correctly adjusted when the stroke is 5-6 mm (fig.
2).
Fig. 2
If the stroke does not correspond to the specified
values it must be reset:
•
Isolate the machine from the compressed air
network and pull the compressed air hose away
from the machine.
•
Unscrew the silencer.
•
On the back of the silencer, you will fine a bore
with a screw inserted inside. The stroke can be
regulated by adjusting the screw by means of a
will cause
hexagonal spanner 2.5 mm (fig. 3).
Fig. 3
•
Turning the spanner clockwise = smaller stroke.
Turning the spanner anti-clockwise = larger stroke.
GB
15
Publicité
Table des Matières
